Floor drain FURO 151

För industri m.m. Finns för flera belastningsklasser.

Valfri längd x bredd 300 mm.
Kvalitet rostfritt EN 1.4301 (SS 2333) alt. syrafast rostfritt EN 1.4404 (SS 2348).
För ingjutning i betonggolv.
Rännöverdelar för klinkergolv, massagolv samt stålslipat betonggolv som är vridbara 360°, vinkelställbara och teleskopiska.
Rännans botten är V-formad för att underlätta självrensning.
Golvrännan har urtagbart vattenlås med handtag.
EPDM-gummitätningar enligt EN 681-1 typ Wc.
Rostfritt, körbart rutgaller, utfört i delar med max vikt 8 kg per del.
Installationstillbehör som ingår: Levereras täckt för att hindra betong från att rinna ner i rännan under gjutning. Rejäla fästöron för förankring i bjälklaget. Dessa ger möjlighet till enkel höjdjustering ovanifrån. Vid massagolv ingår ursparingslister på vidhäftningsflänsar.

R50 For areas with medium weight traffic. Tested acc. to EN 1253-1 with 33 kN load.
M125 For areas with truck traffic. Tested acc. to EN 1253-1 with 85 kN load.

Variants

Variable length:

Length (min-max) 500–20000 mm, in 100 mm intervals.
Fixed width: 300 mm.

Variable depth:

100 mm, a good choice up to 8000 mm.
150 mm, recommended for lengths between 8000–20000 mm.

Outlet placement:
Standard is center-positioned outlet, but placement can be selected.

Indicate c/c from the left.

Clinker floor K3

Floor material: Clinker in adhesives

Water proofing: Floor without waterproofing

Water proofing drain flange: None

Resin flooring

Floor material: Resin flooring

Water proofing: Compound floor

Water proofing drain flange: Recess for resin floor

Concrete floor

Floor material: Concrete floor

Water proofing: Floor without waterproofing

Water proofing drain flange: None

Drains and channels always have a connection pipe and their water flow (V.g.) to consider. Water flow is always measured from the so-called bottom line of the pipe.

To facilitate product selection, we specify the total height (H) of our drains and channels. The total height is the distance from the finished floor surface to where the water exits the product. For bottom outlets, the measurement point is where the spigot begins.

The total height (H) is always made up of the top depth (D) plus the outlet section of the product. If the top depth is increased, the total height will also increase, affecting the product's water flow.

Dimensions for FURO 151:

The upper part depth (D) can vary between 100 and 150 mm. (100 mm is standard for lengths up to 6000 mm).
The total height (H) of FURO 151 thus ranges between 232 and 282 mm. (232 mm is standard for sizes up to 6000 mm).
If an extension or inlet part is selected, the total height (H) increases by 82 mm.

Slope toward outlet:

The product’s slope toward the outlet varies depending on the length and chosen upper part depth. For the standard design with a centrally positioned outlet, the following applies:

For lengths up to 6000 mm and recommended depth of 100 mm, the slope toward the outlet is at least 1%.
For lengths between 6000 – 20 000 mm and recommended depth of 150 mm, the slope toward the outlet is at least 0.8%.

For requirements other than the above recommendations, the slope will be affected.